Copyright © Zhejiang TOT Electric Co., Ltd.
Hotline：400 - 8263390
Paste wallpaper first or install switch socket, do not make a mistake
Decorate the way is long its repair is far xi, I will install edge to search ", a lot of people are edge decorates edge grope, grow in making a mistake however, grow cost in making a mistake, to decorate for the cost drive up really, delay time does not say, waste material and money even.
Today, the editor and we talk about "wallpaper, door, floor, switch socket, in the end which first installed? I hope that after reading this article, you will not make mistakes again!
To get to the point, let's talk about the right process:
1. Installation of switch socket base
Because the base of the switch socket is usually in the wall, so the base is the first installation; Pay attention to the inside of the cleaning of the plaster clean, to avoid the subsequent installation of panels have been dirty wallpaper.
2. Installation of doors and Windows
Door window wants to use water silt when installation, to do not let these things dirty floor, so door window also is before the floor.
3. Floor installation
The floor is installed in front of the wallpaper, is to avoid the installation of floor dust dirty wallpaper.
4. The paper
When sticking wallpaper, need is in switch socket place cut a cross, in order to avoid worker blade scratches beautiful face plate, it is to tear open switch socket face plate first commonly hind sticks wallpaper again;
5. Installation of kicking thread
Because the project activity that kicks a foot line is lesser, suggest wallpaper is stuck good hind installs again, so wallpaper can stick after all, need not worry about close mouth ugly or become warped;
6. Installation of switch socket panel
The switch socket that sticks out when wallpaper is stuck can bring about wallpaper drape, the effect that sticks out is bad; At the same time in the joint is not good, so the general switch socket panel is stuck in the wallpaper after installation;
Attention to detail:
Don't let the workers along the door and window to open the door, the side of the door and window remember to paste!
(2) install wall lamp, wall lamp also want to wait for wallpaper to stick to install again, but you can open the hole first, avoid later hole dirty wallpaper.
(3) hardcover room installed switch socket, it is recommended to switch socket panel unloading, leaving only the base, so paste wallpaper better;